TERRAWET^® Blister Coating G 9-923 ToySafe-045

Markets

• Paperbased Packaging

Application method recommendation

• Wet-in-wet
• Coating unit
• Wet-on-dry
• Sheet-fed offset, coating unit (chambered doctor blade or roller system)
• Sheet-fed offset, coating unit
• Please use printing inks/foil inks suitable for coating.
• In order to guarantee a fast and complete drying, we recommend a sufficient airing of the sheets.
• Recommended coating application: 5 - 10 g/m²/wet Recommendation: double coating
• There must be a suitability for water-based coating if anti-set-off powder is used (do not use mineral powder).
• Using non-absorbent substrates and / or slowly absorbent printing inks, we recommend to plan for the corresponding drying times.
• Stir well before use! Mechanical stirring is recommended.
• Before processing, please check the blister ability.
• The full profile of characteristics of the coating film is available after complete drying.
• There must be a sufficient hardening of the overall system substrate-printing ink-coating before further processing which shoud be checked in the process.
• Resistance against alkali, alcohol and solvents should be given according to DIN ISO 2836, formerly DIN 16524, in order to exclude a change of colour.
• Standard sealing conditions: - Temperature: 180°C - 230°C, depending on used material - Time: 2 - 4 sec., depending on used material - Pressure: 5 bar - In case of suitable board and foil qualities seali
• Recommended temperature: 18°C - 25°C. - Relative humidity: 50 % - 55 %
• For the further processing of the sheets under mechanical load and/or the influence of humidity, a sufficient high basic consistency of the substrate is required.
• Recommended pile temperature: not › 30°C
• Blister cards should be stored cool and on edge.

Product end use

• Toys
• Blister

Substrate recommendation

• Coated Board
• Coated Paper